Toshiba 50A60A Adjusting the color convergence, Press x or to display the center convergence menu

Adjusting the color convergence

This projection TV uses three separate TV tubes: red, green, and blue. The red, green, and blue images are projected onto the screen where they converge to form a full-color picture. You can see a clear picture only when the three images converge correctly. Convergence can drift over time or if you move the TV. If you can see clear images on your TV screen, skip this procedure.

Make this adjustment only after the TV has been on for at least 30 minutes.

To check and adjust the color convergence:

1.Press MENU, and then press x or • until the PICTURE menu appears.

2.Press y or z to highlight CONVERGENCE.

P I CTURE ANTENNA

MODESPORTS

FLESH TONE	ON
NO I SE REDUCTION	OFF
COLOR	COOL
TEMPERATURE
CONVERGENCE

SAVE NEW PREFERENCE

3. Press x or • to display the center convergence menu.

LIGHT RECALL POWER

TV

CABLE MUTE TV/VIDEO TIMER VCR

1	2	3
			CH
4	5	6
7	8	9
		CH RTN	VOL
100	0	ENT
		ADV/
.CAPT	PIP CH		MENU
C
FAV	ENTER		FAV
RESET		ADV/	EXIT

PIP CH

Number

MENU

ENTER

yzx •

EXIT

Setting up your TV

RED	BLUE
ENTER : TO SELECT			COLOR
EX I T : TO		SELECT	POS I T I ON

If you see separate color lines (red, blue, and green or white), you need to adjust the convergence.

4.Press ENTER to highlight RED or BLUE.

5.Press y (up), z (down), x (left), or • (right) to converge the red or blue line into the green (or white) line. When the convergence is adjusted correctly, you will see two single, crossed white lines.

6.Press EXIT to display the circumference convergence menu.

7.Press the corresponding Number button (1–4 and 6–9) to select the area of the screen you want to adjust.

8.Press ENTER to highlight RED or BLUE.

1			2	3
4				6
	PUSH	1 – 9
7			8	9

RED	B L U E
ENTER : TO SELECT		COLOR
EX I T : TO SELECT		POS I T I ON

9.Press yzx • to converge the red or blue line into the green (or white) line.

Repeat steps 8 and 9 until you see two single, crossed white lines.

10.Press EXIT once to select another area to adjust in the circumference convergence menu, and then repeat steps 7–9.

11.Press EXIT twice to close the convergence menus.

20