5.Once the setting is completed...
Press the EXIT button to return to the FUNCTION menu.
To close the main menu, press the EXIT button twice.
Information
PLE
AUTO .............. The brightness of the screen is
adjusted automatically to suit the picture quality.
LOCK .............. The brightness level is set to
minimum.
ORBITER
OFF | Orbiter mode does not function. |
ON | The picture moves around the screen |
| intermittently. |
INVERSE
OFF | Inverse mode does not function. |
ON | The picture is displayed alternately |
| between positive image and negative |
| image. |
| You can set the time by pressing the |
| PROCEED button while “ON” is set. |
WT | The entire screen turns white. |
| You can set the time by pressing the |
| PROCEED button while “ON” is set. |
SCREEN WIPER
OFF | Screen wiper mode does not function. |
ON | Repeatedly moves the white vertical |
| bar from the left end of the screen to |
| the right end at a constant speed. |
| You can set the time by pressing the |
| PROCEED button while “ON” is set. |
Restoring the factory default settings
Select “RESET” from the function menu. Note that this also restores other settings to the factory defaults.
•Only the PLE and ORBITER can be adjusted when an RGB signal is connected.
Setting the time for “ INVERSE”
Set the “INVERSE” or “WHITE” display time and the “WAITING TIME.”
Example: Setting so that the INVERSE mode starts in 30 minutes and proceeds for one and a half hours.
Perform Steps 1-2 on Page 36, then...
3.Use the ▲ and ▼ buttons to select “INVERSE,” then use the and buttons to select “ON.”
L O N G L I F E
PLE | : | AUTO | ||
ORBITER | : | OFF | ||
INVERSE |
|
| : | ON |
| ||||
SCREEN WIPER | : | OFF | ||
SEL. PROCEED OK EXIT RETURN
4. Press the PROCEED button.
The “INVERSE/WT” screen appears.
I N V E R S E / W T
WORKING TIME :
ON
SEL. | ADJ. | EXIT | RETURN |
5.Adjust the time using the and buttons and the ▲ and ▼ buttons.
The mode switches as follows each time the or button is pressed.
I N V E R S E / W T
WORKING TIME | : | 1H |
| : | 30M |
WAITING TIME | : | 0H |
| : | 30M |
SEL. | ADJ. | EXIT | RETURN |
The 1st line of the “WORKING TIME”:
→ ON or 0H ↔ 1H ↔ 2H ↔ 3H ↔ ... ↔ 12H ←
•The “WORKING TIME” (minutes) and “WAITING TIME” cannot be set when the “WORKING TIME” is “ON.”
37
