11 Appendix

Lamp unit replacement and care

Replacing the lamp unit

(User-replaceable component)

WARNING: RISK OF

ELECTRIC SHOCK!

TO REDUCE THE RISK OF ELECTRIC SHOCK, NEVER REMOVE TV COVERS, EXCEPT AS SPECIFIED HEREIN. REFER ALL SERVICING NOT SPECIFIED IN THIS MANUAL TO QUALIFIED SERVICE PERSONNEL. Failure to follow this WARNING may result in death

or serious injury.

The light source for this TV is a mercury lamp with internal atmospheric pressure that increases during use. The lamp has a limited service life that varies depending on product use and user settings.

As is generally the case with all projection TVs that use projection lamps as a light source, the brightness of the lamp in this TV may vary somewhat over the expected service life and will generally decrease over time. The average useful service life for the lamp is approximately 8,000 hours in Low Power mode or 6,000 hours in High Bright mode. See “Selecting the Lamp mode” on page 75 for information on switching the lamp mode. Because these are averages, some lamps will require earlier replacement.

Note : The lamp is warranted only for the periods and to the extent set forth in the Limited Warranty applicable to this set, which is a substantially shorter period of time than the average useful service period. See ÒLimited United States WarrantyÓ on page 107 or ÒLimited Canada WarrantyÓ on page 108, as applicable.

If you use the lamp beyond its service life:

you may notice a reduction in the colors and/or brightness of the picture; and

the strength of the quartz glass in the lamp will be reduced and the lamp may rupture (often making a loud noise when this happens). If the lamp ruptures, the TV will not operate until the lamp unit is replaced.

CAUTION: Always handle the lamp unit with care.

The lamp unit in this TV was designed for safe replacement by consumers; however, if the lamp unit is subjected to intentional abuse (such as excessive mechanical abuse or handling by children or pets), the unit may break, exposing sharp edges or pinch points.

When to replace the lamp unit

You should replace the lamp unit:

if the picture darkens and/or colors fade;

if the screen (lamp) does not light (LED indication #3, page 99); or

if you hear a loud noise and the picture goes black, which may indicate a lamp rupture (LED indication #3, page 99).

To obtain a replacement lamp unit:

In the U.S.:

 

Web

Contact

In warranty

www.tacp.toshiba.com/service

Call toll-free

1-800-631-3811.

 

 

 

 

 

Out of

www.ceaccessories.toshiba.com

Consult your

warranty

 

consumer

 

electronics dealer

 

 

 

 

for availability.

 

 

 

¥ In Canada:

Contact a Toshiba parts distributor by directing your web browser to www.toshiba.ca. Click ÒHome Entertainment,Ó and then click ÒSupport.Ó

Use the replacement lamp unit model listed below only. Using any other lamp may cause damage to the TV and/or lamp.

CAUTION: Always replace with same

type lamp unit: Model No. D95-LMP (Stock no. 23311153)

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

103

 

Page 103
Image 103
Toshiba 56HM195 Appendix, Lamp unit replacement and care, Replacing the lamp unit, When to replace the lamp unit