Toshiba 72MX195, 62MX195 owner manual Viewing the system status

Chapter 6: Setting up your TV

Viewing the digital signal meter

Viewing the system status

You can view the digital signal meter for ANT 1 and ANT 2

To check the system status:

digital TV input sources only.

1. Press MENU and open the Setup menu.

To view the digital signal meter:

2. Highlight Installation and press ENTER. (A new set of

1. Press MENU and open the Setup menu.

Installation menu icons will appear on-screen, as shown

2. Highlight Installation and press ENTER. (A new set of

below right).

Installation menu icons will appear on-screen, as shown in

step 3 below.)

Setup

System Status

Installation

System Infomation

Sleep Timer

On/Off Timer

PC Settings

Setup

HDMI 1 Audio

Auto

Installation

HDMI 2 Audio

Auto

Sleep Timer

Slide Show Interval

2 Sec

On/Off Timer

Navigate Select

CH RTN Back EXIT Exit

Navigate Select CH RTN Back EXIT Exit

PC Settings

HDMI 1 Audio

Auto

3. Open the System Status menu, highlight System

HDMI 2 Audio

Auto

Slide Show Interval

2 Sec

Information, and then press ENTER.

Navigate

Select

CH RTN Back EXIT Exit

4. Use the x • to scroll through the menu bar to check the

3. Open the Terrestrial menu, highlight Signal Meter, and

Product Information and Software Version.

press ENTER.

System Information

System Information

Product Information

Software Version

Brand:

Toshiba

0.3.0

Model:

62MX195

Mar 9 2005 - 12:37:10

IEEE1394 GUID:

00003914-28343803

FW:0.12

Terrestrial

Sub:47

Input Configuration

Channel program

Channel Add/Delete

Done

Done

Signal Meter

To close the screen and return to the Installation menu:

Highlight DONE and press ENTER.

Navigate

Select

CH RTN Back EXIT Exit

To return to normal viewing:

4. Use the yzx • to select the antenna input and digital

Press EXIT.

channel whose signal you want to check.

Note: The physical digital channel number listed in the Signal

Restore Factory Defaults

Meter screen may not correspond to a virtual TV channel

To restore all settings and channels to their factory default

number. Contact your local broadcasters to obtain the RF

values:

channel numbers for your local digital stations.

1. Follow steps 1Ð3 above.

Signal Meter

2. Use the x • to scroll through the menu bar to select

Signal Locked

0

Peak 0

Factory Defaults.

3. Enter your PIN code (or 0000 if no PIN code has been set).

Physical Digital Channel

13

Antenna

1

Virtual Digital Channel

N/A

4. Highlight Yes and press ENTER. The TV will turn off

Done

automatically after a few seconds. After the TV turns off,

To close the screen and return to the Terrestrial menu:

unplug the TV power cord and then plug it in again to

complete the restore process.

Highlight DONE and press ENTER.

System Information

To return to normal viewing:

Press YES to confirm. After the TV

Press EXIT.

turns off, unplug it and plug it dack

in to complete the reset.

Yes

No

To cancel the reset:

Highlight No and press ENTER.

Copyright © 2005 TOSHIBA CORPORATION. All rights reserved. 57

Downloaded from www.Manualslib.com manuals search engine