4 Replacement Procedures
Minnesota 10M/10MG Series Maintenance Manual 4-47
4.18 Fingerprint Module To remove the Fingerprint module, first remove the display assembly, keyboard, and top
cover. Then follow the steps below:
Removing the Fingerprint Module
1. Turn over the top cover. Remove four M2.0x2.5 screws securing the Fingerprint Module
Bracket to the rear side of the top cover. Follow the numbering indicated on the bracket in
the correct sequence.
Figure 4-55 Removing the fingerprint module bracket screws
2. Remove the bracket.
Figure 4-56 Removing the fingerprint module bracket