4 Replacement Procedures
4-48 Minnesota 10M/10MG Series Maintenance Manual
3. Remove the Fingerprint module by lifting it gently.
Figure 4-57 Removing the fingerprint module
Installing the Fingerprint Module
To install the Fingerprint Module, follow the steps below and refer to the figures in the
preceding section:
1. Turn the top cover upside down and place the Fingerprint Module and the
Fingerprint Module Bracket in position on top.
2. Secure the Fingerprint Module bracket with four M2.0x2.5 screws. Follow the
numbering indicated on the bracket in the correct sequence.