Manuals
/
Brands
/
Computer Equipment
/
Printer
/
Toshiba
/
Computer Equipment
/
Printer
Toshiba
B-670-QQ, B-680-QQ owner manual
1
1
32
32
Download
32 pages, 758.42 Kb
TEC Thermal Printer
B-670/680-QQ SERIES
Owner’s Manual
Contents
Main
Page
Safety Summary
WARNING
Meanings of Each Symbol
CAUTION
Precautions
Request Regarding Maintenance
TABLE OF CONTENTS
CAUTION:
1. INTRODUCTION
1.1 APPLICABLE MODEL
1.2 ACCESSORIES
2. SPECIFICATIONS
2.1 PRINTER
Data Matrix
2.2 OPTIONS
2-3
2. SPECIFICATIONS
Tag paper
plus inter label gap length
2.4 RIBBON
E
Type Spool type Width 115 mm ~ 185 mm (See NOTE 5.) Length 300 m Outer diameter 72 mm (max.)
2.3 MEDIA
Fig. 2-1
3. OVERVIEW
3.1 FRONT/REAR VIEW
Fig. 3-1
Rear View
Fig. 3-2
4. DIP SWITCH FUNCTIONS (B-672 only)
The DIP switches are located to the right of the Guide Wheel.
(2) DIP SW 1
NOTES: The Shaded settings are the factory default settings. "OFF" means "OPEN".
4. DIP SWITCH FUNCTIONS (B-672 only)
5. SET UP PROCEDURE
5.1 REQUIREMENTS FOR OPERATION
NOTE:Use an RS-232C cable with imperial (inch) connector securing screws.
Interface Cables
RS-232C Cable description
6. INSTALLING THE PRINTER
6.1 CONNECTING THE POWER CORD AND CABLES
NOTES: Different cables cannot be used at the same time.
6.2 HOLDER STAND INSTALLATION
Turn the POWER SWITCH to OFF before connecting the power cord or cables.
7. LOADING THE RIBBON
NOTE: When removing the ribbon, be careful not to snag the ribbon on the part .
.
CAUTION: When using labels ensure that the head lever is set to position
8. LOADING THE MEDIA
NOTE: Set in the bushes of the Holder Shaft into notches of the Holder Stand securely.
An easy way to set the black mark sensor position
Setting the feed gap sensor position
Page
CAUTION: When using labels ensure that the head lever is set to position
.
9. INSERTING THE OPTIONAL FLASH MEMORY CARD (B-672 only)
10. INSERTING THE OPTIONAL PCMCIA CARD (B-682 only)
11. CARE/HANDLING OF THE MEDIA AND RIBBON
12. GENERAL MAINTENANCE
12.1 CLEANING
Page
12.2 UNDER THE MEDIA GUIDES
12.3 COVERS AND PANELS
12.4 REMOVING JAMMED MEDIA
Cleaning the Cutter Unit
Cleaning the strip unit
Be sure to turn the power off before cleaning the strip unit.
12.5 THRESHOLD SETTING
Threshold setting procedure
13. TROUBLESHOOTING
Page
NOTE: If an error is not cleared by pressing the