Toshiba B-670-QQ, B-680-QQ 6. INSTALLING THE PRINTER

6-1

6. INSTALLING THE PRINTER EO1-33015

6. INSTALLING THE PRINTER

6.1 CONNECTING THE POWER CORD AND CABLES

Fig. 6-1

Fig. 6-2

NOTES: Different cables cannot be used at the same time.

6.2 HOLDER STAND INSTALLATION

Fit the left and right side holders into the dowels of the holder base and fasten the side holders to the

holder base with the thumbscrews.

Left Side Holder

Thumbscrew

Right Side Holder

Dowel

Holder Base

WARNING!

Turn the POWER SWITCH to OFF before connecting the power cord or cables.

[B-672] [B-682]

Expansion I/O

Cable

112

1Power Cord

2Serial Interface Cable (RS-232C)

3Parallel Interface Cable (Centronics)

4Expansion I/O Cable

Contents

Main Page Safety Summary WARNING Meanings of Each Symbol CAUTION Precautions Request Regarding Maintenance TABLE OF CONTENTS CAUTION: 1. INTRODUCTION 1.1 APPLICABLE MODEL 1.2 ACCESSORIES 2. SPECIFICATIONS 2.1 PRINTER Data Matrix 2.2 OPTIONS 2-3 2. SPECIFICATIONS Tag paper plus inter label gap length 2.4 RIBBON E Type Spool type Width 115 mm ~ 185 mm (See NOTE 5.) Length 300 m Outer diameter 72 mm (max.) 2.3 MEDIA Fig. 2-1 3. OVERVIEW 3.1 FRONT/REAR VIEW Fig. 3-1 Rear View Fig. 3-2 4. DIP SWITCH FUNCTIONS (B-672 only) The DIP switches are located to the right of the Guide Wheel. (2) DIP SW 1 NOTES: The Shaded settings are the factory default settings. "OFF" means "OPEN". 4. DIP SWITCH FUNCTIONS (B-672 only) 5. SET UP PROCEDURE 5.1 REQUIREMENTS FOR OPERATION NOTE:Use an RS-232C cable with imperial (inch) connector securing screws. Interface Cables RS-232C Cable description 6. INSTALLING THE PRINTER 6.1 CONNECTING THE POWER CORD AND CABLES NOTES: Different cables cannot be used at the same time. 6.2 HOLDER STAND INSTALLATION Turn the POWER SWITCH to OFF before connecting the power cord or cables. 7. LOADING THE RIBBON NOTE: When removing the ribbon, be careful not to snag the ribbon on the part . . CAUTION: When using labels ensure that the head lever is set to position 8. LOADING THE MEDIA NOTE: Set in the bushes of the Holder Shaft into notches of the Holder Stand securely. An easy way to set the black mark sensor position Setting the feed gap sensor position Page CAUTION: When using labels ensure that the head lever is set to position . 9. INSERTING THE OPTIONAL FLASH MEMORY CARD (B-672 only) 10. INSERTING THE OPTIONAL PCMCIA CARD (B-682 only) 11. CARE/HANDLING OF THE MEDIA AND RIBBON 12. GENERAL MAINTENANCE 12.1 CLEANING Page 12.2 UNDER THE MEDIA GUIDES 12.3 COVERS AND PANELS 12.4 REMOVING JAMMED MEDIA Cleaning the Cutter Unit Cleaning the strip unit Be sure to turn the power off before cleaning the strip unit. 12.5 THRESHOLD SETTING Threshold setting procedure 13. TROUBLESHOOTING Page NOTE: If an error is not cleared by pressing the