Toshiba B-SX5T, B-9700-LAN-QM-R, B9700LANQMR manual Print quality on bumps is not guaranteed

2. SUPPLY SPECIFICATIONS

EO10-33013B

(Revision Date: Apr. 24, 2008)

2.5 SPECIFICATION OF RFID TAG (for B-SX704-RFID-U2-EU/AU -R)

7) Printing on Bump (Chip/Antenna) Area

Embedding RFID tags in labels creates bumps in a chip/antenna area in the labels, causing incomplete printing.

Especially, in the areas 5 mm from and left and right sides of the RFID-tag embedded area shown in the figure below, uneven printing or incomplete printing can occur easily.

* The degree of poor printing quality differs depending on height of a chip/antenna used.

RFID tag embedded area

Print quality on the IC chip is not guaranteed.

Print quality on bumps is not guaranteed.

Print quality on the sides of RFID tag is not guaranteed.

Media feed direction

5mm

Print quality on bumps is not guaranteed.

5mm

8) Ambient temperature

Low operating temperature deteriorates wireless performance, under which conditions writing data on an RFID tag may fail.

9) Strip issue

Stripping performance in strip issue mode depends on the type of glue, tag, and backing paper. For some RFID supplies used, an issue may not be performed properly in strip issue mode.

2-15