APPENDIX 2 MESSAGES AND LEDS ENGLISH VERSION EO1-33034
APPENDIX 2 MESSAGES AND LEDS
EA2- 1
APPENDIX 2 MESSAGES AND LEDS
Appendix 2 describes the LCD messages displayed on the operation panel.
Symbols in the message
1: : The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.
2: ****: the number of unprinted media. Up to 9999 (in pieces)
3: %%%%%%%: ATA Card’s remaining memory 0 to 9999999 (in K bytes)
4: ###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)
5: &&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)
LED Indication
No. LCD Message POWER ONLINE ERROR Printer Status Restoration by
RESTART ke
y
Yes/No
Acceptance of
Status Request
Reset Command
Yes/No
ON LINE z In online mode ----- Yes
1 ON LINE ~ z In online mode (The printer in
communication) ----- Yes
2
HEAD OPEN z z The print head block is opened in online
mode. ----- Yes
3
PAUSE **** z z The printer is paused. Yes Yes
4 COMMS ERROR z A parity, overrun, or framing error has
occurred during communication through
the RS-232C.
Yes Yes
5
PAPER JAM **** z The media is jammed during paper feed. Yes Yes
6 CUTTER ERROR**** z A problem has occurred with the cutter
module. Yes Yes
7
NO PAPER **** z The media has run out, or the media is
not loaded properly. Yes Yes
8
NO RIBBON **** z The ribbon has run out. Yes Yes
9 HEAD OPEN **** z Feed or printing was attempted with the
print head block open. Yes Yes
10
HEAD ERROR z There is a problem with the print head. Yes Yes
11 EXCESS HEAD TEMP z The print head is overheated. No Yes
12 RIBBON ERROR**** z
The ribbon has been torn. A problem
has occurred with the sensor that
determines the torque for the ribbon
motor.
Yes Yes
13
REWIND FULL **** z An overflow error has occurred in the
rewinder unit. Yes Yes
14
SAVING%%%%%%%
or
SAVING ###&&&&
z In writable character or PC command
save mode ----- Yes
15
FLASH WRITE ERR. z An error has occurred while writing to
flash memory or ATA card. No Yes
16
FORMAT ERROR z An erase error has occurred in
formatting the flash memory or ATA
card.
No Yes
17
FLASH CARD FULL z Data cannot be stored because the flash
memory or ATA card is full. No Yes
18
Display of error
message (See Notes.) z A command error has occurred in
analyzing the command. Yes Yes
19
POWER FAILURE z A power failure has occurred. No No
20 INTIALIZING… z z A flash memory card is being initialised. ----- -----
21 100BASE LAN
INITIALIZING… z z 100 Base LAN Board is being
initialized. ----- -----