3EN
INTRODUCTION
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
WARNING:
Batteries (Battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, re, or the like.
LASER SAFETY
This apparatus employs a laser. Only a qualied service person should remove the cover or attempt to service this
apparatus, due to possible eye injury.
CAUTION: Use of controls or adjustments or performance of procedures other than those specied herein may
result in hazardous radiation exposure.
CAUTION: Visible and invisible laser radiation when open and interlocks defeated. Do not stare into beam.
LOCATION:
Inside, near the deck mechanism.
IMPORTANT COPYRIGHT INFORMATION
Unauthorized copying, broadcasting, public performance and lending of discs are prohibited. This product incorporates
copyright protection technology that is protected by U.S. patents and other intellectual property rights. Use of this
copyright protection technology must be authorized by Macrovision, and is intended for home and other limited
viewing uses only unless otherwise authorized by Macrovision. Reverse engineering or disassembly is prohibited.
Do not place the unit on the furniture that is capable of being tilted by a child and an adult leaning, pulling, standing
or climbing on it. A falling unit can cause serious injury or even death.
FCCWARNING
Thisequipment may generate or use radio frequency energy. Changes or modications to this equipment may
causeharmful interference unless the modications are expressly approved in the manual. The user could lose the
authorityto operate this equipment if an unauthorized change or modication is made.
RADIO-TVINTERFERENCE
Thisequipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residentialinstallation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
andused in accordance with the instructions, may cause harmful interference to radio communications. However,
thereis no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interferenceto radio or television reception, which can be determined by turning the equipment o and on, the user
isencouraged to try to correct the interference by one or more of the following measures:
1)Reorient or relocate the receiving antenna.
2)Increase the separation between the equipment and receiver.
3)Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
4)Consult the dealer or an experienced radio/TV technician for help.
ThisClass B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
ALWAYS plug the product into an outlet that is located in such a manner that it can be easily unplugged in case the
product requires service.
ToAvoid the Hazards of Electrical Shock and Fire
Donot handle the AC power cord with wet hands.
Donot pull on the AC power cord when disconnecting it from an AC outlet. Grasp it by the plug.
Donot put your ngers or objects into the unit.
Locationand Handling
Donot install the unit in direct sunlight, near strong magnetic elds, or in a place subject to dust or strong vibration.
Avoida place with drastic temperature changes.
Installthe unit in a horizontal and stable position. Do not place anything directly on top or bottom of the unit.
Dependingon your external devices, noise or disturbance of the picture and/or sound may be generated if the unit is
placedtoo close to them. In this case, please ensure enough space between the external devices and the unit.
Dependingon the environment, the temperature of this unit may increase slightly. This is not a malfunction.
Be sure to remove the disc and unplug the AC power cord from the outlet before carrying the unit.
DewCondensation Warning
Dewcondensation may form inside the unit in the following conditions. If so, do not use this unit at least for a few
hoursuntil its inside gets dry.
-The unit is moved from a cold place to a warm place.
-Under conditions of high humidity.
-After heating a cold room.
•
•
•
•
•
•
•
•
•
INTRODUCTION C
ONNECTIONS
P
LAYBACK
F
UNCTION
SETUP
O
THERS