Toshiba BDX2000KU owner manual Network Connection, EnableEasy, Connection Test, EnableCustom

FUNCTION SETUP

Network Connection

Enable(Easy)

Set up the network connection settings in order to use the BD-Live function with a BD-Live disc.

Connection Test

After you made IP address/DNS settings or when a LAN cable is connected, always perform the connection test to check if the connection is correctly made.

1In stop mode, press [SETUP].

2Use [K / L] to select , then press [ENTER].

3Use [K / L] to select “Others”, then press [ENTER].

4Use [K / L] to select “Network Connection”, then press [ENTER].

5Use [K / L] to select “Connection Test”, then

press [ENTER].

Connection test will start automatically and the test result will appear right after the connection test finishes.

• “Testing...”	: The test is in progress.
• “Pass”	: Connection test is successfully completed.
• “Fail”	: Connection test failed.

Check the connection settings. Press [ENTER] to go to the list of network status confirmation screen.

Network settings are set to the following settings initially. (In most cases, you can connect to the Internet without making any changes to the default settings.)

- IP Address Setting	Auto(DHCP)
- DNS Setting	Auto(DHCP)
- Proxy Setting	Do Not Use
- Connection Speed	Auto
- BD-Live Setting	Allow

If you want to set the network settings back to the default settings as above (except “BD-Live Setting”), follow the procedure below.

1Follow steps 1 to 4 in “Connection Test” on this page.

2Use [K / L] to select “Enable(Easy)”, then press [ENTER].

•The unit will start the connection test automatically and the test result will appear right after the test finishes.

•After the connection test finishes, press [ENTER] to go to network status confirmation screen.

3Press [ENTER] to activate the network settings and set the network connection automatically. Press [SETUP] to exit.

Others

Connection Test

IP Address	xxx.xxx.xxx.xxx
Subnet Mask	xxx.xxx.xxx.xxx
Default Gateway	xxx.xxx.xxx.xxx
Primary DNS	xxx.xxx.xxx.xxx
Secondary DNS	xxx.xxx.xxx.xxx
then press ‘ENTER’

6Press [ENTER] to go back to the previous screen, or press [SETUP] to exit.

Note

•If the connection test passes, you can enjoy the BD-Live functions using the Internet without making any extra settings.

•If the connection test fails, you may need to change the MAC address settings of your router. You can check the MAC address of this unit on “Enable(Custom)” screen.

•“Connection Test” is not available when “Disable” is selected in “Network Connection”.

Note

•The setting of “BD-Live Setting” will not be set back to the default, even if you follow the procedure.

Enable(Custom)

In following cases, select “Enable(Custom)” to set each setting as necessary.

-When connection test failed with the setting of “Enable(Easy)”.

-When instructed by your Internet service provider to make specific settings in accordance with your network environment.

•IP Address Setting / DNS Setting

1Follow steps 1 to 4 in “Connection Test” on this page.

2Use [K / L] to select “Enable(Custom)”, then press [ENTER].

3Use [K / L] to select “IP Address Setting”, then press [ENTER] repeatedly to select the desired setting.

“Auto(DHCP)”	: If your router has DHCP server
	function, select “Auto(DHCP)”.
“Manual”	: If your router does not have DHCP
	server function, select “Manual”.

46 EN