Toshiba D-R17DTKB owner manual Connecting to External Equipment, AV3 Front

E7J70BD_EN.book Page 21 Monday, May 7, 2007 3:31 PM

Note

•Because HDMI is an evolving technology, it is possible that some devices with an HDMI input may not operate properly with this unit.

•When using an HDCP-incompatible display device, the image will not be viewed properly.

•Among the devices that support HDMI, some devices can control other devices via the HDMI connector; however, this unit cannot be controlled by another device vice the HDMI connector.

•The audio signals from the HDMI connector (including the sampling frequency, the number of channels and bit length) maybe limited by the device that is connected.

•Among the monitors that support HDMI, some do not support audio output (for example, projectors). In connections with device such as this unit, audio signals are not output from the HDMI output connector.

•When this unit’s HDMI connector is connected to a DVI-D compatible monitor (HDCP compatible) with an HDMI-DVI converter cable, the signals are output in digital RGB.

•If the connected equipment is not compatible with HDMI BITSTREAM, DTS sound will not be output.

•When the power failure occurs, or when you unplug the unit, some problems in the HDMI setting might occur.

Please check and set the HDMI setting again.

Connecting to External Equipment

This unit has three input terminals, AV1 or AV2 on the rear panel and AV3 on the front panel. Be sure that all the units are off before making connections.

Recording from a DVD player, Satellite Box or other Audio-Video equipment with a Scart output socket (AV2)

AV output jack (Scart)

Scart cable (not supplied)

AV2 (DECODER)

	IN		COAXIAL
			DIGITAL AUDIO OUTPUT
		Y	PCM/BITSTREAM
			L
		PB/CB
			R
	OUT	PR/CR		AV2 (DECODER)	AV1 (TV)
DVB-T	ANALOG	COMPONENT	ANALOG
ANTENNA		VIDEO OUTPUT	AUDIO OUT

Note

•When you record a TV programme from a Satellite Box, you must connect a Scart cable to AV2(DECODER). (See page 42.)

•When AV2 is connected, the signal from the AV2 will be output automatically. If you want to monitor the signal from other input, you must press [DISPLAY] first. Then, select the desired input to monitor with [INPUT SELECT ].

Recording from a camcorder or other Audio-Video equipment with no Scart output socket (AV3)

If no S-Video input jack is available, connect to VIDEO input jack on the front panel using an RCA Video cable.

Change the setup when using S-VIDEO input jack. (See page 44.)

AV3 (Front)

1080p	1080i	720p	576p/480p
STOPPLAYREC
		AV3
S-VIDEO		VIDEO	L R
S-Video cable			Audio cable
(not supplied)			(not supplied)
S-VIDEO		AUDIO
OUT			OUT

EN 21

Introduction Connections Basic Setup Recording

Playback

Editing Function Setup Others