February 2002 © TOSHIBA TEC 4 - 11 FC-210/310 TROUBLESHOOTING
[The original does not reach the aligning roller.]
Is the pick-up roller or feed roller stained?
Clean the roller.
Is the gap between the aligning plate and the feed roller too small?
Adjust the gap.
Is the transporting force of the pick-up roller or the feed roller insufficient?
Replace the roller.
[The original stops, skewed on the original glass.]
Is the aligning roller stained?
Clean the roller.
Is the transport belt stained?
Clean the belt.
Is the RADF correctly installed?
Properly install the RADF in parallel to the copier.
Make sure that the skew and height are properly adjusted.
[The side edges of the original are out of alignment with the side edges of the copy.]
Is the slides set too wide in relation to the width of the original?
Align the slides with the width of the original.
Shift the original feeding tray back or forth to adjust.
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO