February 2002 © TOSHIBA TEC 5 - 33 FC-210/310 UPDATING THE FIRMWARE
5.3.1 System firmware
(1) ROM type
There are two types of ROM to be downloaded.
(a) ROM for application downloading
The area in the FROM on the SYS board is updated. This ROM is used for the normal update.
The data to be overwritten by this ROM are as follows.
• System software basic section
* This area cannot be downloaded using PC.
• Program internal application
• UI data fixed section
• UI data common section
• Language(UI) on the display panel
(b) ROM for UI data downloading
The language data in the HDD are updated.
The data to be updated by this ROM are as follows.
• UI data: The 1st to 7th languages
When downloading is performed using the ROM for UI data downloading, only UI data in the HDD are
updated.
To make the result of updating effective, it is necessary to copy the updated data into the FROM by
selecting a desired language in the setting mode “Selection of language(UI) on the display panel (08-
220)".
(2) Jig board
Two types of the ROM mentioned above use the jig board K-PWA-DLS-320.
( Page. 5-32)
Note: Pay attention to the position and direction of the ROM when it is attached to the jig board.