1. CAUTIONS ON USE AND INSTALLATION

•Handling the unit.

Do not drop, jolt, or vibrate, as this may result in damage to the unit. This may cause problems. Treat the camera cables carefully to prevent cable problems, such as breaks in the cable and loose connections.

•Install the camera in a location free from noise. If the camera or the cables are located near power utility lines or a TV, etc. undesirable noise may ap- pear on the screen. In such a case, try to change the location of the camera or the cable wiring.

•Operating ambient temperature and humidity. Do not use the camera in places where tempera- ture and humidity exceed the specifications. Pic- ture quality will deteriorate and internal parts may be damaged.

Be particularly careful when using in places ex- posed to direct sunlight. When shooting in hot places, depending on the conditions of the object and the camera (for example when the gain is in- creased), noise in the form of vertical strips or white dots may occur.

This is not a malfunction.

•When not using the camera for extended periods of time.

Switch the control unit off and disconnect the power supply.

•Avoid using or storing the camera in the fol- lowing places:

Places filled with highly flammable gas.

Places near gasoline, benzene, or paint thinner. Places subject to strong vibration.

Places containing chemicals (such as pesticides), rubber or vinyl products for extended periods of time.

•Do not shoot intense light.

When intense light enters, vertical stripes or transverse bands may appear on the screen. This is not a malfunction. Ghosts may occur when there is an intense light near the object. In this case, change the shooting angle.

•Moire

A moire pattern is an interference pattern generated when two repetitive line patterns overlap. This is not a malfunction. Eliminating the repetitive line patterns, or aligning the two patterns, will eliminate the moire.

•Handling of the protection cap.

Keep the protection cap away from children as they may pose a choking hazard. The protection cap protects the image sensing plane when the lens is removed from the camera head, do not discard.

•When cleaning the camera.

Unplug the power source before cleaning. Clean with a soft dry cloth only. Do not use any chemicals or chemically treated cloths. Chemicals may damage coatings, printing or the paint work. When cleaning the lens, use lens cleaning paper.

•Installation without a tripod.

Before installing the camera, make sure that the location can withstand the total weight of the camera.

If this is not the case, reinforce the area to prevent the unit from dropping, which may result in damage to the unit or personal injury.

•This camera is for indoor use only.

2. COMPONENTS

 

1

Camera ...................................................................................................................

1

2

Accessories

 

 

a

Instruction manual ........................................................................................

1

 

b

Tripod mount ................................................................................................

1

 

c Screws (for the tripod mount) .......................................................................

4

6