3. NAMES AND FUNCTIONS

1 Optical area

2

DC IN 12V terminal

 

4

DISP button

 

6

MENU UP button

 

8

DATA UP (AWB) button

3 REMOTE

9

DATA DOWN button

7

MENU DOWN button

terminal

 

5 PAGE button

10 FORMAT switch

11

HD-SDI terminal

[ Front ][ Rear ]

 

12Mounting holes M3

13Mounting holes M2

[ Bottom ]

Optical area

DC IN 12V terminal REMOTE terminal DISP button PAGE button MENU UP button MENU DOWN button DATA UP (AWB) button

DATA DOWN button FORMAT switch

(1)Effective scanning lines

(2)Vertical frequency

HD-SDI terminal

Mounting holes M3

Mounting holes M2

The protection cap is attached on the lens mount portion. After removing the cap, mount the lens. Be careful not to scratch or touch the optical area.

Accepts a DC power input (12V).

To connect to a RS-232C device for remote control of the camera. Used when switching the display.

Used when switching to the menu and when selecting the menus. Select the function to be confirmed or changed on the menu. Select the function to be confirmed or changed on the menu.

Changes the value of the function selected by the MENU (UP/DOWN) button. (Also used when performing AWB.)

Changes the value of the function selected by the MENU (UP/DOWN) button.

Switches between 1080i and 720p. (Factory default setting: 1080i)

* Switching the effective scanning between 1080i and 720p changes the angle of view on a monitor.

Switches between 59.94 Hz and 50 Hz. (Factory default setting: 59.94 Hz) Outputs a serial digital signal. (BNC connector)

Used to attach the camera to a mount.

Used to attach the camera to a mount.When using a tripod, attach the supplied tripod mount to these holes.

7