Toshiba KV-KLR Setting up a PTZ Camera, Figure 6.2c, Figure 6.2d, Figure 6.2e, Use the Brown and Red Wires

64

Setting up a PTZ Camera

3)Locate the PTZ adapter (Figure 6.2c).

4)Connect the two wires of the included PTZ adapter to the PTZ camera (See Figure 6.2a). Since each camera is different, refer to your PTZ camera manual for detailed instructions.

5)Connect the other end of the adapter to the DVR unit (See Figures 6.2D and 6.3E)

6)Assign the PTZ Camera an ID number that coincides with the number assigned to it by the DVR unit. For Example: If you have the camera plugged into Input #5 on the DVR then you must set the PTZ unit to ID #5.

7)Inside the DVR setup, select the PTZ menu option and select the desired camera number.

8)Select RS-232 as the default connection type. THIS IS IMPORTANT. Even though the PTZ camera is expecting an RS-422/485 connection you must still select the RS-232.

9)Enable the PTZ functions of the camera by placing a check in the PAN/TILT CONENCTION checkbox.

10)Once enabled, the Protocol can be edited. Select the appropriate Protocol.

NOTE: Protocols are a set of instructions written by the manufacture of the PTZ cameras that allow software programs such as this DVR to control their functions. The majority of the major PTZ manufacture protocols are included in this software.

11)Press the APPLY button and exit Setup.

12)From the Main Display Screen select the PTZ button. The PTZ Control options will open.

13)Select the PTZ camera to control by clicking on its video on the main display screen.

The camera number should appear inside the PTZ controls.

14)Using the PTZ controls, you should now be able to move the PTZ around.

Figure 6.2cUse the Brown and Red WiresFigure 6.2dFigure 6.2e