Toshiba MD20Q41, MD13Q41 owner manual Parental control setting, To change the parental level

￿￿￿￿￿￿￿￿￿	￿
	￿￿￿
￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿￿

Parental control setting

Some discs are specified not suitable for children. Such discs can be limited not to play back with the unit.

1)Press C or D to select “Parental”, then press B or A until the level you require appears.

•Level Off: The parental control setting does not function.

•Level 8: All DVD software can be played back.

•Level 1: DVD software for adults cannot be

played back.

Select from the level 1 to level 8. The limitation will be more severe as the level number is lower.

2)Press C or D to select “Password”.

Press Number buttons (0–9)to input a 4-digit password. Be sure to remember this number!

• If you input a wrong number, press CANCEL.

3)Press ENTER to store the password.

Note: Now the rating is locked and the setting can not be changed unless you enter the correct pass word.

4)Press OPEN/CLOSE to activate Parental control setting. (See “Temporary disabling of rating level by DVD disc” on page 44.)

Notes:

•Depending on the discs, the unit cannot limit playback.

•Some discs may not be encoded with specific rating level information though its disc jacket says “adult.” For those discs, the age restriction will not work.

To change the parental level

1)Press C or D to select “Password”.

2)Press Number buttons (0–9)to enter the password you have stored.

3)Press ENTER.

• The rating is now unlocked.

4)Press C or D to select “Parental”, then press B or A to change the parental level.

5)Press C or D to select “Password”, then press Number buttons (0–9)to enter the password. Note: You can change the password if you want.

6)Press ENTER.

Now the parental level is changed and locked.

If you forget the password...

1.Press OPEN/CLOSE to open the disc tray.

2.Remove the disc.

3.Press OPEN/CLOSE again to close the disc tray. “No Disc” appears on the screen.

4.While holding STOP down on the front panel, press 7 on the remote control. “PASSWORD CLEAR” appears on the screen.

5.Enter a new password again.

Note:

If each setup (pages 41~43) has been completed, the unit can always be worked under the same conditions (espe- cially with DVD discs).

Each setup will be retained in the memory even if you turn the power off.

Function setup

43

5R80101D [E] (P39-44) 43 2/24/05, 10:15 AM