7-5 Addendum (Service Supervisor Information)
This section of the manual should not be used by untrained personnel – blender controller and/or program can be compromised!
WARNING! Hidden, programmable features and hidden menu pages should not be made available to floor operators or inexperienced plant personnel. These pages include the Service Supervisor Information addendum located in this section. Unauthorized changes to these factory settings by inexperienced operators may prevent the unit from operating properly, and may void part or all of the warranty.
After all selections are made, keep pressing the “Done” key until the unit returns to the Recipe menu.
Call the Service Department for assistance or for further explanation of these or any other programmable features, which may or may not be shown in this manual. Information included in this manual is subject to change without notice.
Passwords |
| |
• | User Password | “5413” |
• | Maintenance Password | “3145348” |
Caution! Maintenance password should only be supplied to qualified personnel! The program can be compromised.
Programmable Settings
The Slide Gate/Auger blender software program has been designed to allow some customizing to achieve certain desired operating parameters. The following is a listing of the selections that are “field” programmable, followed by the procedure for doing so.
This menu is accessed by pressing the manufacturer’s icon when in the “Setup” Directory Screen menu.
Typical Operator Setup Screen
Touch this icon and enter in the Service Password to access the Engineering Only Directory
Enter the long password “3145348” and press “Enter”. The factory setup section displays the “Engineering only” screen. The screen similar to that shown below should be displayed and use the keystrokes described herein to change or toggle the parameters.
882.00207.00 | Chapter 7: Appendix | 86 of 102 |
