Operating Basics

Changing Ultra Slim Bay modules

Ultra Slim Bay is a single-drive bay that accommodates either of the following modules.

Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II

Ultra Slim Bay HDD Adaptor II

Only use the Ultra Slim Bay modules that are provided with your computer.

Do not use any Ultra Slim Bay DVD Super Multi drive or HDD Adaptor from other models including PORTEGE M700/M710, otherwise the computer might be damaged.

This section explains how to change modules in the Ultra Slim Bay. The illustrations show replacement of the Ultra Slim Bay DVD Super Multi (Double Layer) Drive Kit II with the Ultra Slim Bay HDD Adaptor II.

To avoid injury, do not put your hand into the Ultra Slim Bay slot.

Removing a optical disc drive module

To remove the optical disc drive, follow the steps as described below:

1.Save your work.

2.Turn the computer's power off - ensure that the Power indicator is off.

3.Remove all cables and peripherals that are connected to the computer.

4.Close the display panel.

Always make sure the display panel is closed in Laptop mode before turning the computer upside down.

Wait for all disk indicators to go out before you turn over the computer and do not lay the computer down gently. Shock can damage the HDD or other components.

5.Turn the computer upside down and remove the battery pack (refer to Replacing the battery pack section in Chapter 6, Power and Power-Up Modes, if required).

6.Remove the Ultra Slim Bay lock screw from the Lock position.

7.Set the Ultra Slim Bay lock screw in the Unlock position.

8.Slide the Ultra Slim Bay latch to the unlock position.

9.Grasp the hook in the concave of the optical disc drive and slide it out.

The optical disc drive and other Ultra Slim Bay modules can become hot with use. Be careful when removing the module.

User’s Manual

4-30