3 Tests and Diagnostics 3.29 SETUP
3-100 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)
or BackSpace. Press ↓ to move the cursor to the right and ↑ to move the
cursor to the left when you set the date and time.
For the Alarm Time, set the time to turn on the power automatically. The
“second” cannot be set. When it is set to “Disabled”, the time to turn on
automatically is not set.
For the Alarm Date Option, set the date to turn on the power automatically.
When it is set to “Disabled”, the time to turn on automatically is not set.
The Wake-up on LAN is a function to turn on the power automatically by the
call from the administrator. It can be set to “Enabled” only when “Built-in
LAN” is set to “Enabled”. To activate this function, use the AC adapter.
NOTE: 1. Do not remove the AC adaptor and battery pack at the same time when you
use this feature. If you do so, data saved by the resume function will be lost.
You must also reset this option.
2. If you have set a password and the computer boots by the Auto Power On
function and Resume is on, the computer will start with the instant security
function enabled. The password = message is not displayed; however, you
must enter the password to use the computer.
3. This option is enabled only once, the setting is reset, after booting up.
(d) Diagnostic Mode
This option enables/disables the HW Diagnostic test function.
Disabled Disables the HW Diagnostic test function. (Default)
Enabled Enables the HW Diagnostic test function.
9. Configuration
This option displays the configuration method.
(a) Device Config.
The devices are initialized when the PNP OS loads.
Setup by OS Operating system sets devices that it can control.
(Default)
All Devices BIOS sets all devices.
NOTE: When using installed OS, selecting “Set by OS” is recommended. But, when
executing a diagnostic program, select “ All Devices”.