Toshiba R200 4.16 MP FPC

4 Replacement Procedures 4.16 MP FPC
4.16 MP FPC
Removing the MP FPC
To remove the MP FPC, follow the steps below and refer to Figure 4-23.
1. Remove the following screw and kill switch holder.
• M2×3C S-FLAT HEAD screw x1
2. Remove the following screws and disconnect the MP FPC from the connector
CN9500 on the system board.
• M2×3C S-FLAT HEAD screw x2
M2×3C S-FLAT
HEAD
M2×3C S-FLAT HEAD
Kill switch holder
MP FPC
CN9500
Figure 4-23 Removing the MP FPC
4-34 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)