Problem | Procedure |
The "USB Wakeup | When "System ON CDP Charge Mode" or "USB |
function" does not | Sleep and Charge function" is enabled, the "USB |
work. | WakeUp" function does not work for ports that |
| support the Sleep and Charge function. |
| In that case, use an USB port that does not have |
| the USB Sleep and Charge |
| icon ( ) or change to disable both "System ON |
| CDP Charge Mode" and "USB Sleep and Charge |
| function". |
|
|
In addition to the information in this section, please also refer to the documentation supplied with your eSATA device.
Problem | Procedure |
eSATA device does | Remove the eSATA device from the computer and |
not work | then reconnect it to a free port it in order to ensure |
| it is firmly attached. |
| A connected eSATA device may not be recognized |
| if it is connected to the computer's eSATA/USB |
| combo port while the computer is in Sleep Mode or |
| Hibernation Mode. If this occurs, disconnect the |
| eSATA device and then reconnect the device while |
| the computer is turned on. |
|
|
| Ensure that any required eSATA device drivers are |
| properly installed - to achieve this you should refer |
| to both the device documentation and the |
| operating system documentation. |
| If you are still unable to resolve the problem, |
| contact TOSHIBA Support. |
|
|
Please also refer to Chapter 3, Operating Basics, for further information on installing and removing memory modules.
User's Manual |