Toshiba RD-XS32SB owner manual See, To check space remaining on a disc Press the Remain button

Note on recording on a DVD-R disc

Confirm disc compatibility and prepare an available DVD-R disc to record on ( page 6, 9).

To play a DVD-R disc recorded on this recorder on other devices, finalize the DVD-R disc on this recorder. ( page 132)

The finalization permanently disables the disc’s writeability. (Cancelling the finalization is not possible.)

•DVD-Video finalize process cannot be cancelled if once executed on a DVD-R disc.

•On DVD-R discs recorded on other devices, you cannot execute DVD-Video finalize process or add recordings on this recorder.

•DVD-R discs with the method of ”DVD-Video Creation” have been alreadly executed the DVD- Video finalize process. Therefore, they cannot be added the contents.

If you want to record contents which will be copied to a DVD-R/RW disc later on

See page 36.

To check space remaining on a disc

1)Press the REMAIN button.

The current capacity per disc is displayed at the bottom of the screen. The current capacity of the selected drive is displayed on the front panel display.

2)After checking the capacity, press the button again to turn off the display.

Note

•You can also check the capacity of the disc by selecting

“Disc budget calculation” from the Quick Menu within the REC MENU ( page 44).

When “HDD recording is not possible due to...” appears

The HDD is full. To record new content, delete unnecessary titles or transfer some content to a DVD- RAM disc.

Programmed recording and operational status The recorder gives priority to programmed recordings in every operating mode. Even if the recorder is playing, recording or editing, or even in standby mode, at a starting time of a programmed recording the recorder will make itself ready or stop those operations and start the recording.

However, “Creating a DVD-Video” ( page 122) and “DVD-Video finalizing process” ( page 132) operations may have priority over programmed recordings.

When the programmed settings overlap

Before the first recording is completed, the second programme is scheduled to begin recording. When using a DVD-RAM disc, the recording of the previous programme stops 15 seconds before the next programme starts. (If you have been recording over 8 hours on the same drive, the current recording stops approximately 2 minutes before the next programme starts.)

When using a DVD-R or DVD-RW disc, the recording of the previous programme stops about 2 minutes before the next programme starts, to complete data process. In this 2 minutes, you cannot operate the loaded DVD-R or DVD-RW disc.

On a programmed recording across the change- over of Daylight-saving time

•When the clock gains across Daylight-saving time during a programmed recording, it means that the recording completion time is consequently set one- hour earlier. In this case, set the programmed recording one-hour longer in advance. If not set accordingly, the programmed recording stops one- hour shorter.

•When the clock loses across Daylight-saving time during a programmed recording, it means that the recording completion time is consequently set one- hour later. In this case, as the programmed recording continues one-hour longer, delete unnecessary chapters by chapter dividing after the completion of recording.

Introduction RecordingPlayback

Editing

LibraryFunction setupOthers

Notes

•The “Loading” icon appears in the top right of the screen after recording. This indicates that the unit is executing the final recording process (writing managing information). Operations other than changing channels cannot be done until this icon disappears. The time for executing this process differs depending on the recording time or capacity of the disc.

•Note that all recording content may be deleted if the unit is disconnected from a wall outlet, or a power failure occurs, during recording.

•If a power failure occurs within 5 minutes prior to the programmed recording start time, the programmed recording may not be executed.

•A programmed recording may not be executed correctly if scheduled when Daylight-Saving time starts or ends.

27