Toshiba RD-XS32SB owner manual To stop a programmed recording

5)Correct the parameters of the timer program if necessary.

(Skip to step 7 if you do not need this.) You can change “Media”, “Mode”, “Rate” and “Audio”.

Select an item you want to modify and press the ENTER button. The item will be ready to be altered. Press the ADJUST button to modify. When complete, press the ENTER button.

You can adjust to a lower mode (SP to LP) and/or lower the rate to reduce the quality of the recording, and thus provide more disc capacity (space).

6)Press .

Program modification is registered.

7)Press REC MENU to exit the GUI.

Notes

•When a Reservation disc ( page 49) is inserted in the recorder, you cannot check the remaining volume of other discs.

•The nearest 8 programs are calculated at a time.

•While the recorder is preparing for or executing a programmed recording, any program modification cannot be registered. Only programs which will start after 5 minutes or later can be modified.

•Available disc volume is not displayed for a DVD-R/RW disc on which DVD-Video finalize process was executed.

To stop a programmed recording

To finish,

Press on the front panel twice.

When you press it once, a message appears. While the message is displayed, press the button once again.

To pause recording,

Press on the front panel.

To resume recording, press it again.

Turning the power off automatically after completing a programmed recording

1)While executing a programmed recording, press

QUICK MENU.

The Quick Menu appears.

2)Press / to select “Auto power off” then press ENTER.

Keeping the power on even after the programmed recording finished

If the recorder turns itself on to execute a programmed recording, it will turn itself off after finishing the recording. You can restrict this and keep the recorder powered on.

1)While executing a programmed recording, press QUICK MENU.

2)Press / to select “Continuous power on” then press ENTER.

Delaying the end time of a programmed recording while it is recording

While a programmed recording has started, open the lid of the remote control and press EXTEND.

The first press displays the programmed end time (in the front panel display).

Each time you press the button, it is delayed 10 minutes, up to 60 minutes.

Notes

•Pressing a button except EXTEND in the above procedure will set the currently selected delay.

•You cannot delay the end time of a programmed recording which will end within 1 minute from the current time.

•Even if you delay the end time of a programmed recording, the recording will stop when the disc is exhausted. Also it will stop if 8 hours elapsed.

Introduction RecordingPlayback

Editing

LibraryFunction setupOthers

45