Toshiba S20 instruction manual Method of F07optical connector assembly, Removal of housing

9.5Method of F07optical connector assembly

Assembly work of optical connector shall conform to the following-given steps. For detail, refer to the instruction manual attached to the assembly tools.

Precautions of optical connector assembly work

On assembling an optical connector, observe the following-listed precautions.

∙Prepare exclusive-use assembling tools for processing optical connector.

∙A simple training is necessary for the understanding of the use of the exclusive-use assembling tools and for the

assembling method of optical connector. For detail, inquire to the cable manufacturer.

Recommended optical connector assembling tools

Manufacturer: Sumitomo Electric Industries, Ltd.

Agency: Takachiho Electric Co., Ltd.

Model of optical connector assembling tools: CAK-1062

(1)Cut off about 110 to 150 mm of the edge portion of the optical fiber cable using a cutter knife or other means, and inserts the optical fiber through the cord bush.

Optical fiber

110 to 150mm

Cord bush

Figure 9.9 Fiber cut off

(2)Using a jacket remover (use the hole at 2.2 side of label indication), remove the housing to about 45 mm in length. At that moment, the step between two housings shall be within 1 mm.

Housing

45±2mm

Figure 9.10 Removal of housing

32 ASC25 Instruction Manual