Problem | Procedure |
No display | Try adjusting the contrast and brightness controls |
| on the external monitor. |
| Press the FN + F5 hot key in order to change the |
| display priority and ensure that it is not set for the |
| internal display only. |
| Check to see if the external monitor is connected. |
| When the external monitor is set as the primary |
| display device in extended desktop mode, it will not |
| display when the computer wakes up from Sleep |
| Mode if the external monitor has been |
| disconnected while in Sleep Mode. |
| To keep this from happening, do not disconnect |
| the external monitor while the computer is in Sleep |
| or Hibernation Mode. |
| Remember to turn off the computer before |
| disconnecting the external monitor. |
| When the display panel and an external monitor |
| are set to clone mode and they are turned off by |
| the timer, the display panel or the external monitor |
| may not display when turned on again. |
| If this occurs, press FN + F5 to |
| panel and external monitor to clone mode. |
|
|
Display error occurs | Check that the cable connecting the external |
| monitor to the computer is firmly attached. |
| If you are still unable to resolve the problem, |
| contact TOSHIBA Support. |
|
|
Modem
This information is applicable to the models equipped with a
Problem
Communication software can’t initialize modem
You can hear a dial tone but can’t make a call
Procedure
Make sure the computer's internal modem settings are correct - please refer to the Phone and Modem Options link within the Windows Control Panel.
If the call is going through a Private Branch Exchange (PBX), take care to ensure that the communication application's tone dial detection feature is disabled.
User's Manual |
