Toshiba SD-6980SY manual Choosing a Connection, Before Connecting the DVD Player

00873A-SD-6980SY-1 8/22/05 4:41 PM Page 14

Connections

Choosing a Connection

The following shows examples of connections commonly used to connect the DVD player with a TV and other components.

Before Connecting the DVD Player

-Always turn off the DVD player, TV, and other components before you connect or disconnect any cables.

-Refer to the user’s manual of the additional components (such as a TV) you are connecting for more information on those particular components.

Connection to a TV (Video)

1

Using video/audio cables, connect the VIDEO (yellow)/AUDIO (red and white) OUT terminals on the rear of the DVD player to the VIDEO (yellow)/AUDIO (red and white) IN terminals of your TV.

2

Turn on the DVD player and TV.

3

Press the input selector on your TV remote control until the Video signal from the DVD player appears on the TV screen.

Note

RED	WHITE	YELLOW
	Audio Cable	Video Cable

RED WHITE YELLOW

-Noise may be generated if the audio cable placed too close to the power cable.

-If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 20 to 22)

-The number and position of terminals may vary depending on your TV set. Please refer to the user's manual of your TV.

-If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the DVD player.

-If you press the V.OUT button when DVD Player is in stop mode or no disc is inserted, the Video Output mode changes in the following sequence: (COMPOSITE/S-VIDEO➝ COMPONENT(I-SCAN)➝ HDMI/COMPONENT(P-SCAN))

If HDMI/COMPONENT(P-SCAN) mode is selected and your TV does not support HDMI or progressive scan, you cannot see any picture. Press the V.OUT button until the picture can be seen on the screen.

-When the Video Output in Setup menu is set to HDMI/COMPONENT(P-SCAN), the Video and S-Video Outputs do not work.

ENG-14