Toshiba SD-V280 manual Timer recording

Timer recording

1 Press VCR MENU.

2 Press SET + or – to select one of the program line, then

3 Press SET + or – to select the date, then press ENTER.

4 Set the start time, end time, channel and tape speed as

5 To enter other programs, repeat step 2 through 4.

• To return to the normal screen, press VCR

MENU twice.

6 Press TIMER REC. The timer symbol () will appear on the display and the VCR stands by for recording.

At the same time, VCR mode will change to DVD mode automatically.You can use DVD even if the VCR is in the Timer recording mode.

If you do not use the DVD, turn the power off.

One-touch Timer Recording (OTR)

1 Load a cassette tape with the erase prevention tab intact.

The VCR will automatically turn on.

Press SP/SLP to select the desired tape speed SP or

2 SLP.

The tape counter and SP or SLP will appear on the screen for about 4 seconds.

3 Set “TV” or “CATV” option to the appropriate position. TV - VHF/UHF channels CATV - CABLE TV channels

4 Press Number button or CH / to select the channel to be recorded.

5 Press OTR. Recording begins. Press the button again to stop recording after 30 minutes. Each additional press of OTR will increase recording time as shown in the chart below,

up to a maximum of 5 hours.

The OTR and recording time will appear on the screen for about 4 seconds. And, “ ”will keep blinking in the display.

To cancel OTR

Press STOP or turn off the power.

" " will appear on screen for about 4 seconds.

Note:

If you wish to watch the DVD playback during OTR or standard recording, press DVD/VCR to change to DVD mode and perform the DVD playback.

2B01607AE Q Sheet 6 17/7/2002, 9:32