Inserting Batteries

Slide the battery compartment

Install two “AAA” batteries

3

Replace the compartment

cover in the direction of the

(supplied), paying attention to the

cover.

1 arrow.

2 polarity diagram in the battery

 

compartment.

Battery precautions

The precautions below should be followed when using batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re- versed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.

4.If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

5.Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery manufacturer’s directions.)

Introduction

Remote control basics

•Press POWER ( ) to turn the DVD VCR on or off.

•Select your desired operating mode (DVD or VCR) using VCR DVD.

(DVD or VCR indicator on the front panel will show you which mode is selected.)

•Press CH + or CH –to move through the channels one channel at a time.

•The CH +/–( / ) and SET +/–(/) are also used to navigate on-screen menu system.

•You can directly access specific channels using Number buttons.

•Each press of VCR DVD on the remote control, switches the screen between the VCR screen (VCR mode) and the DVD screen (DVD mode).

Operation

 

• Aim the remote control at the remote sensor and press control buttons to

 

operate.

 

• Operate the remote control within 30° angle on either side of the remote

Approx. 7 meters

sensor, up to a distance of Approx. 7 meters.

 

13