Toshiba SD-V291 Setting the video channel

Basic setup

Setting the video channel	POWER
	3
When a TV is connected with the 75 ohm coaxial cable only.	4
	TV/VCR
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR's channel selector, the TV must be set to	VCR DVD
channel 3 or 4 (video channel).

Setting the video channel

	Press and hold 3 or 4 on the remote for 3					For a push-button TV tuner
1 seconds in standby mode.						If CH 3 or 4 corresponding to the video channel cannot
						be tuned on your TV, proceed as follows: set the VCR
	3		4	The video channel will		3/4 channel selector and the TV to CH 3 or 4, play
		OR				back a prerecorded tape and tune the TV to receive a
				start to flash for 3
						sharp color picture from the video cassette recorder.
				seconds in the display
				window.		Refer to your TV owner's manual for details.
					Notes:
					• If the unit does not operate properly, or No key operation
					(by the unit and/or the remote control): Static electricity,
2
	Press POWER to turn on the DVD/VCR.				etc., may affect the player's operation. Disconnect the AC
					power cord once, then connect it again.
					• During the DVD playback if you change the operating mode
					from DVD to VCR, the DVD will continue to play back the disc
					and stop after about 5 minutes.
3	Press VCR DVD selector to select the VCR mode.
	VCR			The VCR indicator on the
	DVD

front panel will light.

4 Turn ON the TV and set to CH 3 or 4 to correspond with the channel selected in step 1.

5 Press TV/VCR to select the VCR position.

TV/VCR	The VCR indicator will
	appear in the display
	window.

6 Select any channel to receive a TV station in your area. The channel number will appear on the screen for about 4 seconds.

22