Toshiba SD-V291 19

Note: The S-video output and component video output transports the DVD-video signal exclusively and will deliver enhanced DVD video picture performance.

Connecting to an audio system and TV equipped with S-video input/component video inputs

Signal flow

Connections

			(white)	To ANALOG
				AUDIO OUT
			(red)
To S-	To PR/CR	To PB/CB	To wall outlet
To S-	To PR/CR	To PB/CB	To Y
VIDEO	VIDEO	VIDEO	VIDEO
OUT	OUT	OUT	OUT

When you make this connection, set the S-VIDEO/ COMPONENT Video selector switch to the desired position.

And also you must select the corresponding video input on your TV.

Component video	Audio cable (not supplied)
Component video
cable (not supplied)	To audio inputs of
	To audio inputs of
To Y video input	the amplifier
To Y video input	(red)	(white)
	(red)	(white)

To PB/CB video input

To PR/CR video input

To S-video input

S-video cable (not supplied)

If you connect the DVD/VCR to your TV with the DVD OUT jacks, select the corresponding video input on your television to watch DVD video discs.

TV or monitor with	Audio system
ColorStream®
component video inputs

Component video (ColorStream® ) outputs/inputs

Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest quality DVD picture playback.

Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR) In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case, adjust the TV or monitor for optimum performance.

Notes:

•Refer to the owner’s manual of the connected equipment as well.

•When you connect the DVD/VCR to other equipment, be sure to turn off the power and unplug all of the equipment from the wall outlet before making any connections.

•If you place the DVD/VCR near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD/ VCR away from the tuner and radio.

•The output sound of the DVD/VCR has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.

•Turn off the amplifier before you connect or disconnect the DVD/VCR’s power cord. If you leave the amplifier power on, the speakers may be damaged.

•An S-Video connection is superior to Video (Yellow) output. Use this method for DVD playback when the connected television has S-Video input, and does not have component video inputs.