Wireless remote controller kit | Installation Manual |
|
10 SELF-DIAGNOSIS TABLE AND MEASURES
Lamp indication of Signal receiving unit
: Goes off
: Blink
Lamp indication | Cause | Measures |
| Power supply is not turned on. | Check cable |
| Miscabling between Signal receiving unit | connection and correct it. |
No indication even if the | and indoor unit |
|
|
| |
remote controller is |
|
|
operated. |
|
|
| Defective connection between Signal |
|
| receiving unit and indoor unit |
|
| Miscabling or defective connection between |
|
| indoor and outdoor units. |
|
| Protective device of outdoor unit works. | Check outdoor unit. |
Blinks alternatively |
|
|
| Protective device of indoor unit works. | Check indoor unit. |
Blinks alternatively
11 CAUTIONS FOR INSTALLATION OF THE REMOTE CONTROLLER
•To operate the remote controller by fixing it to the wall, etc. with a remote controller holder, turn on the fluorescent lamp, operate the remote controller at the position to be fixed, check the air conditioner normally operates, and then mount it.
•When the room temperature is sensed by the remote controller, mount the remote controller paying attention to the following items.
•Place not exposed directly to cold or hot wind.
•Place not exposed directly to the sunlight.
•Other places where the remote controller is not influenced.
EN |
– 12 – |
