Preparing and using the remote control
Operating a computer using the remote control
■Loading dry-cell batteries
into the remote control
qRemove the battery cover.
■Operating the remote control
Turn on the ON/OFF switch of the remote control.
Point toward the projector’s infrared remote sensor, and press a button on the remote control.
• Operating the projector from the front
A computer can be operated using the projector’s remote control. This function is available on any computer with the Windows 98/98SE, Windows Me, Windows 2000, or Windows XP OS, that is equipped with a USB port which can support USB1.1 (The mouse remote control receiver is also supported on OS 9 or OS X for the Macintosh). However, please note that Toshiba does not guarantee the operation of all computers.
1Connecting a computer
Connect the mouse remote control receiver (supplied) to a computer.
wInsert the dry-cell batteries.
Be sure to align the plus and minus ends of the batteries properly.
Approx. 15°
Approx.5m
To USB port
Mouse remote control receiver
The remote control may fail to operate if the mouse remote control receiver is exposed to bright sunlight or fluorescent lighting.
In such a case, change position or direction of the mouse remote control receiver and retry.
Preparations
Two batteries (LR03, SIZE AAA) are used.
e Replace the battery cover.
• Operating the projector from the rear
Approx. 15°
Approx.5m
2Operating a computer
Operate remote control’s buttons towards the mouse remote control receiver.
● Moving the mouse pointer |
Press the mouse control button in the direction you wish the mouse pointer to move, |
then press. |
● To left click |
Press the |
● To right click |
Press the |
● To drag and drop |
Holding down the |
pointer is over the desired location, then release the |
•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
•Remove batteries from remote control when not using for extended periods.
•If the remote control stops working, or if its range decreases, replace all the batteries with new ones.
The remote control
•Turn off the ON/OFF switch of the remote control when not in use or to store in baggage.
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Do not drop or bang.
•Do not leave in hot or humid locations.
•Do not get wet or place on top of wet objects.
•Do not take apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.
● Using the computer’s page up [↑] and down [↓] function |
Press the PAGE+ and PAGE- buttons to switch PowerPoint® slides. |
Remote Control Front | Remote Control Rear | |
| EASY SETUP |
|
Mouse control |
| |
PAGE – | PAGE + | |
|
| |
20 | 21 |
