Preparing and using the remote control
Placement
■Loading dry-cell batteries
into the remote control
qRemove the battery cover.
wInsert the
Be sure to align the plus and minus ends of the batteries properly.
■Operating the remote control
Point the remote control toward the projector’s infrared remote sensor, and press a button on the remote control.
• Operating the projector from the front
Approx. 15°
Approx.5m
Placement Styles
As shown in the figures below, this device can be placed in 4 different styles.
The factory setting is
|
| |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Preparations | ||||||||||
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
WARNING
Two batteries (R6, SIZE AA) are used.
eReplace the battery cover.
(1) | (2) |
|
Dry-cell batteries
• Operating the projector from the rear
Approx. 15°
Approx.5m
•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.
•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.
•If the projector is
Projection Distance and Size
Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for
Screen As seen from above
•Before using the batteries, be sure to observe the Safety Precautions described in previous pages.
•Remove batteries from remote control when not using for extended periods.
•If the remote control stops working, or if its range decreases, replace all the batteries with new ones.
90°
a (min length) = projection size (inches) ⋅ 0.04064
a (max length) = projection size (inches) ⋅ 0.04878
The remote control
•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.
•Do not drop or bang.
•Do not leave in hot or humid locations.
•Do not get wet or place on top of wet objects.
•Do not take apart.
•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.
•For further information of the mouse remote control, see the Owner’s Manual of the Mouse Remote Control.
As seen from the side
Lens center
H 
90°
a
a is the distance (m) between the lens and the screen, and corresponds to a range of 1.50 m to
10.00m. H is the height from the image bottom to the center of the lens.
projection | projection distance a (m) | height (H) | |
size (inches) | min length | max length | (cm) |
(zooming max) | (zooming min) | ||
30.75 | — | 1.50 | 15.46 |
40 | 1.63 | 1.95 | 20.12 |
60 | 2.44 | 2.93 | 30.18 |
80 | 3.25 | 3.90 | 40.23 |
100 | 4.07 | 4.88 | 50.29 |
150 | 6.10 | 7.32 | 75.44 |
200 | 8.13 | 9.76 | 100.58 |
246 | 10.00 | — | 123.72 |
18 | 19 |
