20Operations
(Continued)
Notes
• “ | ” is displayed on the screen if the |
projector does not receive any signal from the | |
connected equipment. Put the equipment in | |
playback mode. | |
• Due to the lamp characteristic, flickers may | |
occasionally occur in a picture. This is not | |
malfunction of the unit. | |
SELECT/ADJUST
ON
ON/STANDBY MENU | ENTER | INPUT |
LAMP
TEMP
ON/STANDBYIndicators
Notes
•Even after turning the power off, the intake and exhaust fans continue to work for a while to cool the inside of the projector.
•Immediately after the power off, the projector may not be turned on while the LAMP indicator is flashing in green.
•Before unplugging the power cord, make sure that the fans are stopped.
• When an RGB source is selected and no |
signal is sent from the computer for about 30 |
minutes, the projector turns to standby mode |
for power saving. It automatically turns on |
when the signal resumes. Pressing |
ON/STANDBY also turns it on. |
• While operating the projector, “ ” may be |
displayed on the screen. This means that the |
operation cannot be completed. |
ON/
STANDBY
CALLON/STANDBY
RGB VIDEO
AUTO SET KEYSTONE RESIZE
KEYSTONE
FREEZE MUTE MARKER
MENUENTER
RESET
Turning the power off
1)Press ON/STANDBY after using the projector.
An instruction message appears.
2)Press ON/STANDBY again.
The LAMP indicator turns off, and the projector turns to standby mode. (The ON idicator lights in orange.)
3)After confirming the exhaust fan stops, unplug the power cord.
The ON indicator turns off.
Correcting the keystone distortion
A picture may be expanded on the upper side if projected upward from the projector lifted up by the foot adjuster. The projector can correct this keystone distortion automatically.
Press KEYSTONE.
The keystone distortion is corrected automatically.
To correct further, make the “Keystone” adjustment on the menu. 26
(Continued)