Basic operation (Continued)
5Projector placement angle adjustments
The placement angle and the height of the projected image can be adjusted by the foot adjuster.
qLift up the front of the projector to
the desired angle, then press the foot adjuster release button.
The foot adjuster extends. Release the button to lock the position.
w To fine adjust the angle, twist the foot adjuster.
e To adjust the horizontal angle, use the right and left tilt adjusters.
•To stow the foot adjuster, hold up the projec- tor while pressing the foot adjuster release button, then slowly lower the projector.
6Adjusting the screen size and focus
q Use the zooming lever to adjust the screen size. w Use the focusing ring to adjust the focus.
7Adjusting the volume with the 
buttons
The speaker volume can be adjusted when an audio signal is being input.
Notes
•Note that lamp characteristics may rarely cause the brightness to fluctuate slightly.
•A lamp is consumable item. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on conditions of use.)
•The LCD panel is made using extremely advanced technology, but there may be black spots (pixels that do not light) or bright spots (pixels that are constantly lit) on the panel. Please note that these are not malfunctions.
•Although this projector supports a wide range of RGB signals p.57 , any resolutions not supported by this projector (XGA) will be expanded or shrunk, which will affect image quality slightly. To view
•With some models of computer having LCD displays or the like, displaying images simultaneously on the projector and the monitor’s display may prevent the images from displaying properly. If this happens, turn off the computer’s LCD display. For information on how to turn off the LCD display, see the owner’s manual of your computer.
•If no signal is being input from the connected equipment or signal input is stopped while projecting, the “No signal” will appear.
•If a signal not supported by the projector is input, the “Unsupport signal” will appear.
•If an unavailable operation button is pressed, the 
icon will appear.
Using handy features
■Using auto setting (Only for input from computer)
This function sets up the projector to the optimum state such as | Remote |
sampling phase, frequency, screen position, and clamp for each | Control |
type of the input signal by using simple operations. |
|
Press the remote control’s AUTO SET button.
For computer input, the 
icon will appear during processing. You can set as well by selecting [Auto setting] in the Image adjustment menu p.37 .
Notes
•The image may not be projected or auto adjustment/setting may not be performed correctly for input signals other than those supported by the projector p.57 , p.58 .
•If auto setting fails adjustment, adjust manually with [Position] in the Image adjustment menu p.37 .
■Correcting the keystone distortion
When the projector placement angle against the |
|
|
screen is changed while projecting the image, | Control panel | Remote |
the picture will undergo keystone (trapezoidal) | Control | |
distortion. |
|
|
This projector is capable of correcting this keystone |
|
|
distortion. |
|
|
Before correction After correction |
|
|
1Press the KEYSTONE button.
The Keystone menu appears. By default, [Auto
Item |
|
| Description |
|
| ||
Auto | Automatically corrects the vertical distortion. | ||
| Press | . |
|
|
|
| |
Screen shrinking at | Screen shrinking at | ||
| bottom |
| top |
|
|
|
|
Operations
28 | 29 |
