Users Manual TOPAS900 Flash V2.1
LOAD“ to load a program. The TMPro Debugger displays the source code in the source window and automatically downloads the user program to the TOPAS900 Flash board.
After downloading a user program to the TOPAS900 Flash board RAM it can be started (clicking go button) or traced (clicking one of the step buttons) by TMPro debugger. If a user program is running the red LED on the TOPAS900 Flash board is switched on permanently. Running programs can be stopped by TMPro debugger (click stop or finish button), by a breakpoint being defined before (break set at a specific source code line) or by actuating NMI switch on the TOPAS900 Flash board. The next statement of the user program to execute is marked in the source code window.
For further details please refer to the help manual in the “Toshiba Debugger” program group.
After starting the TMPro Debugger, a profile file which comprises a lot of settings for a user program should be loaded or – if not existing – created.
If TMPro is called the first time after installing the creation of a new debugging profile is necessary. From this profile further individual profiles can be derived. Before starting the TMPro debugger be sure that the Toshiba ROM monitor is installed properly on the TOPAS900 Flash board (external flash ROM) and is started (by pressing the reset button). The yellow led must be flashing as an indicator for “Toshiba ROM monitor running”.
4.2.2.1.How to create a new debugging profile (*.tdp)
The following steps show how to setup a new profile. Just follow the steps below, which give a short description. Please refer to the TMPro help file for further information (topic: Starting the Profile Wizard and Wizard Processing).
∙Launch the TMPro Debugger by clicking its icon in the start menu. 
∙Select New Profile from the File menu
∙A dialog will come up and requires information about the connection. Select the
HWU Elektronik Oberhausen | Page 23 |
