Toshiba WLT66 Input selection AV connections, Analogue switch-off, Input signal selection

Input selection and

AV connections

Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6 for a clear view of the back connection recommendations.

Most media recorders and decoders send a signal through the SCART lead to switch the television to the correct Input socket.

Alternatively press the external source selection button Buntil the picture from connected equipment is shown.

This button must be used to view equipment connected using the COMPONENT VIDEO INPUT (EXT3C).

An S in the display e.g. B2S (EXT 2S), indicates the input is set for an S-Video signal.

Input selection

Use the Input Selection if the television does not switch

over automatically.

1Press Bto select B1, B2, B3(C) (EXT1-3), HDMI1, HDMI2 or PC.

HDMI™ displays equipment connected to Input HDMI on the back of the television. It is designed for best performance with 1080i high definition signals.

PC displays a computer connected to Input RGB/PC on the back of the television.

2To return to television mode press and hold B and then select DTV or ATV.

Analogue switch-off

This is a digital television which is integrated to allow the use of both digital and analogue services. However, during the lifetime of this set it is very likely that analogue services will be switched off to allow for more new digital services.

This ‘switch-off’ will happen in a number of phases, which will be advertised in your area well in advance. It is recommended that at each phase the television is re-tuned to ensure that existing and new digital services can be viewed without disruption

(see the 'Auto tuning' section).

INPUT signal selection

This specifies the type of signal going into SCART 2 (EXT2)

on the back of the television. Please refer to the

manufacturers instructions for the connected equipment.

1In the SET UP menu press Q until

AV connection is highlighted, then press OK.

	SET UP	1/2
Language		English
Country		UK
Auto tuning		OK
Manual tuning		OK
Antenna Amplifier		On
AV connection		OK
MENU Back	EXIT Watch TV

2With S or R select either AV or S-VIDEOas the required input for EXT2.

	AV connection
PC/HDMI1 audio		PC
HDMI1 audio		Digital
EXT1 output		DTV
EXT2 input
		S-VIDEO
EXT2 output		DTV
Monitor (Audio)		Fixed
MENU Back	EXIT Watch TV

If the colour is missing try the alternative setting.

31