TP-Link TL-SG2452, Tl-SB2216 manual Front panel of TL-SG2424P is shown as the following figure

Gigabit Smart Switch

The front panel of TL-SG2424P is shown as the following figure.

LEDs

LED Mode Switch Button

Reset

10/100/1000Mbps RJ45 Port

SFP Port

FFFFFFFFFFF Front Panel of TL-SG2424P

LEDs

TL-SG2424P has an LED mode switch button which is for switching the LED status indication. When the Speed LED is on, the port LED is indicating the data transmission rate. When the PoE LED is on, the port LED is indicating the power supply status. By default the Speed LED is on. Pressing the mode switch button, the Speed LED will turn off and the PoE LED will light up. Then the PoE LED will turn off after being on for 60 seconds and the Speed LED will light up again.

When the Speed LED is on, the port LED is indicating the data transmission rate.

LED	Status		Indication
	On		The Switch is powered on
Power	Off		The Switch is powered off or power supply is abnormal
	Flashing		Power supply is abnormal
System	Flashing		The Switch works properly
	On/Off		The Switch works improperly
		On	A 1000Mbps device is connected to the corresponding
	Green		port, but no activity
10/100/		Flashing	Data is being transmitted or received
1000Mbps		On	A 10/100Mbps device is connected to the corresponding
	Yellow		port, but no activity
		Flashing	Data is being transmitted or received
	Off		No device is connected to the corresponding port

When the PoE LED is on, the port LED is indicating the power supply status.

LED	Status	Indication
	On	The Switch is powered on
Power	Off	The Switch is powered off or power supply is abnormal
	Flashing	Power supply is abnormal
System	Flashing	The Switch works properly
	On/Off	The Switch works improperly

Introduction 03