TP-Link TL-WPA271, TL-WPA281 - page 22

TL-WPA281/TL-WPA271 Wireless N Powerline Extender

15

The WPS Configuration Screen of Wireless Adapter

Step 4: Wait for a while until the next screen appears. Click Finish to complete the WPS configuration.

The status LED on the Powerline Extender will light green for five minutes if the device has

been successfully added to the network.

The WPS Configuration Screen of Wireless Adapter

II. By PIN

If the new device supports Wi-Fi Protected Setup and the PIN method, you can add it to the network by

PIN with the following two methods.

Method One: Enter the PIN into my Powerline Extender

Step 1: Keep the default WPS Status as Enabled and click the Add device button in Figure 3-5, then

the following screen will appear.

Contents

Main COPYRIGHT & TRADEMARKS FCC STATEMENT FCC RF Radiation Exposure Statement CE Mark Warning National restrictions DECLARATION OF CONFORMITY Important Safety Instructions CONTENTS Chapter 1 Introduction 1.1 System Requirement 1.2 Package Contents 1.3 Conventions Chapter 2 Hardware Connection 2.1 Before You Begin 2.2 LED Indicator 2.3 Physical Interface 2.4 Hardware Connection Page Page Chapter 3 Configure the Device 3.1 Login 3.2 Status Page 3.3 WPS Page Page Page Page Page 3.4 Network 3.5 Wireless Page Page Page Page Page Page Page Page ) Note: 3.6 Powerline ) Page Page 3.7 System Tools Page Page Page Page ss Network Chapter 4 Connecting to Wirele 4.1 In Windows 7 4.2 In Windows Vista Page 4.3 In Windows XP Page Chapter 5 Pair Buttons 5.1 Pair (Secure with 128 bits-AES) 5.2 Setting Up a Powerline Network with the Pair Button 5.3 Reset Appendix A: Troubleshooting Guide Appendix B: Specifications