TP-Link TL-WPA271, TL-WPA281 3.4 Network

TL-WPA281/TL-WPA271 Wireless N Powerline Extender
17
The WPS Configuration Screen of Wireless Adapter
) Note:
The default PIN code of the Powerline Extender can be found on its label or on its WPS configuration
page as shown in Figure 3-5.
You will see the following screen when the new device has successfully connected to the network.
Figure 3-8 Successfully Added a New Device
) Note:
a. The WPS LED on the Powerline Extender will light green for five minutes if the device has been
successfully added to the network.
b. The WPS function cannot be configured if the Wireless function of the Powerline Extender is
disabled. Please make sure the wireless function is enabled before configuring the WPS.
3.4 Network
You can configure the IP parameters of the Powerline Extender on this page.
Figure 3-9 Network