TP-Link TL-WR843ND manual Connecting the Router, System Requirements

Models: TL-WR843ND

1 121
Download 121 pages 7.23 Kb
Page 15
Image 15
Chapter 2. Connecting the Router

TL-WR843ND300Mbps Wireless AP/Client Router User Guide

Chapter 2. Connecting the Router

2.1 System Requirements

Broadband Internet Access Service (DSL/Cable/Ethernet)

One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is connected directly to the Ethernet.)

PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

TCP/IP protocol on each PC

Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari

2.2 Installation Environment Requirements

Place the Router in a well ventilated place far from any heater or heating vent

Avoid direct irradiation of any strong light (such as sunlight)

Keep at least 2 inches (5 cm) of clear space around the Router

Operating Temperature: 0~40(32~104)

Operating Humidity: 10%~90%RH, Non-condensing

2.3 Connecting the Router

To connect the Router, please follow the steps below:

1)Locate an optimum location for the Router. The best place is usually at the center of your wireless network. The place must accord with the Installation Environment Requirements.

2)Adjust the direction of the antenna. Normally, upright is a good direction.

After finishing the steps above, please choose the working mode you need and carry out the corresponding steps. There are two working mode supported by this router: WISP Client Router and Standard Wireless Router.

- 7 -

Page 15
Image 15
TP-Link TL-WR843ND manual Connecting the Router, System Requirements, Installation Environment Requirements