Trane Modu manual Table O-GI-6. Gbas Analog Input Setpoints

General

Owner Information

Table O-GI-6. GBAS Analog Input Setpoints

Control Parameter	Signal Range	Setpoint Range
Occupied Zone Cooling Setpoint	0.5 to 4.5 vdc	50 to 90 F
(CV units only)
Unoccupied Zone Cooling Setpoint	0.5 to 4.5 vdc	50 to 90 F
(CV andVAV)
Occupied Zone Heating Setpoint	0.5 to 4.5 vdc	50 to 90 F
(CV units only)
Unoccupied Zone Heating Setpoint	0.5 to 4.5 vdc	50 to 90 F
(CV andVAV)
Supply Air Cooling Setpoint	0.5 to 4.5 vdc	40 to 90 F
(VAV units only)
Supply Air Hydronic Heating Setpoint	0.5 to 4.5 vdc	40 to 180 F
(VAV units only)
Space Static Pressure Setpoint	0.5 to 4.5 vdc	0.03 to 0.30 IWC
Supply Air Pressure Setpoint	0.5 to 4.5 vdc	0.0 to 5.0 IWC
(VAV units only)

Note: 1. Input voltages less than 0.5 vdc are considered as 0.5 vdc input signal is lost, the setpoint will “clamp” to the low end of the setpoint scale. No diagnostic will result from this condition.

2.Input voltages greater than 4.5 vdc are considered to be 4.5 vdc.

3.The actual measured voltage is displayed at the HI.

Table O-GI-7. GBAS Input Voltage Corresponding Setpoints

Volts	Temp.	Volts	Temp.	Volts	Temp	Volts	Temp
	(F)		(F)		(F)		(F)
0.5	50	1.6	60	2.6	70	2.7	80
0.6	51	1.7	61	2.7	71	2.8	81
0.7	52	1.8	62	2.8	72	2.9	82
0.8	53	1.9	63	2.9	73	3.0	83
0.9	54	2.0	64	3.0	74	3.1	84
1.0	55	2.1	65	3.1	75	3.2	85
1.1	56	2.2	66	3.2	76	3.3	86
1.2	57	2.3	67	3.3	77	3.4	87
1.3	58	2.4	68	3.4	78	3.5	88
1.5	59	2.5	69	3.5	79	3.6	89

SCXG-SVX01B-EN 83