Transcend Information TS16G~64GCF400, 400X CompactFlash Card, Transcend Information Inc

TS16G~64GCF400				400X CompactFlash Card
	Signal Name	Dir.	Pin	Description
-CE1, -CE2		I	7,32	These input signals are used both to select the card and to indicate to the card
				whether a byte or a word operation is being performed. -CE2 always accesses
(PC Card Memory Mode)				the odd byte of the word.-CE1 accesses the even byte or the Odd byte of the
Card Enable				word depending on A0 and -CE2. A multiplexing scheme based on A0,-CE1,
				-CE2 allows 8 bit hosts to access all data on D0-D7. See Table 27, Table 29,
				Table 31, Table 35, Table 36 and Table 37.
-CE1, -CE2				This signal is the same as the PC Card Memory Mode signal.
(PC Card I/O Mode)
Card Enable
-CS0, -CS1				In the True IDE Mode, -CS0 is the address range select for the task file
				registers while -CS1 is used to select the Alternate Status Register and the
(True IDE Mode)
				Device Control Register.
				While –DMACK is asserted, -CS0 and –CS1 shall be held negated and the
				width of the transfers shall be 16 bits.
-CSEL		I	39	This signal is not used for this mode, but should be connected by the host to PC
(PC Card Memory Mode)				Card A25 or grounded by the host.
-CSEL				This signal is not used for this mode, but should be connected by the host to PC
(PC Card I/O Mode)				Card A25 or grounded by the host.
-CSEL				This internally pulled up signal is used to configure this device as a Master or a
(True IDE Mode)				Slave when configured in the True IDE Mode.
				When this pin is grounded, this device is configured as a Master.
				When the pin is open, this device is configured as a Slave.
D15 - D00		I/O	31,30,29,28,	These lines carry the Data, Commands and Status information between the host
(PC Card Memory Mode)			27,49,48,47,	and the controller. D00 is the LSB of the Even Byte of the Word. D08 is the LSB
			6,5,4,3,2,	of the Odd Byte of the Word.
			23, 22, 21
D15 - D00				This signal is the same as the PC Card Memory Mode signal.
(PC Card I/O Mode)
D15 - D00				In True IDE Mode, all Task File operations occur in byte mode on the low order
(True IDE Mode)
				bus D[7:0] while all data transfers are 16 bit using D[15:0].
GND		--	1,50	Ground.
(PC Card Memory Mode)
GND				This signal is the same for all modes.
(PC Card I/O Mode)
GND				This signal is the same for all modes.
(True IDE Mode)
Transcend Information Inc.				11
				V1.0