Installing Model 1004 Repeater Hub
NOTE: Rackmount screws and clip nuts are NOT provided with the Model 1004 Repeater Hub.
To install the Model 1004 Repeater Hub in
T R A N S I T I O N
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 |
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1.Locate four (4) screws (and clip nuts, if necessary) for each Model 1004 Repeater Hub to be installed.
2.Carefully align the Model 1004 Repeater Hub between the 19- inch rack mounting rails at the installation position.
3.Install two screws through right front bracket and two screws through left front bracket, using clip nuts if necessary.
To install the Model 1004 Repeater on table or other flat surface:
1.Carefully turn Model 1004 Repeater Hub to side.
2.Install four (4) rubber feet (provided with repeater hub):
•Remove protective paper from adhesive surface of rubber foot.
•Position rubber foot at bottom corner of repeater hub.
•Secure rubber foot to repeater hub surface.
•Repeat for remaining rubber feet.
3.Return Model 1004 Repeater Hub to upright position.
Connecting Cable to SIC/RJ-45 Connectors
Connections between installed Model 1004 Repeater Hub SICs or between a Model 1004 Repeater Hub SIC and a hub or terminal device include:
•Female AUI Connector/10Base5
•Male AUI Connector/PC
•RJ Connector/10BaseT
•BNC Connector/10Base2
•ST Connector/Fiber Optic
BNC Connector/10Base2 Connection
The thinnet coaxial card
NOTE: Verify that coax cables on Model 1004 Repeater Hub are terminated properly at both ends.
| 50 ohm terminator | (In a coax thinnet | ||||
|
|
|
|
|
| |
|
|
|
|
|
| installation, the first and |
|
|
|
|
|
| |
|
|
|
|
|
| last device in a |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| must be terminated with a |
|
|
|
|
|
| 50 ohm terminator.) |
|
|
|
|
|
| Additionally, the 10Base2 |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| segment must be grounded |
|
|
|
|
|
| to “earth ground” at one |
|
|
|
|
|
| end. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
50 ohm terminator
9 | Model 1004 | 10 |