Installing the ET0010A
Figure 15 Insert the power supply cable into the connector on the rear panel
5Attach the mounting brackets to the rack’s front supports with the large
Figure 16 Front view of ET0010A mounting brackets and power supply
Solid Surface Installation
When installing the ET0010A on a solid surface, have the following tools and materials available to attach the rubber feet to the bottom of the unit:
●External power supply
●(4) rubber feet, supplied in the Accessory Kit (item 3 in Figure 11).
●(4) small silver screws with
●#1 Phillips screwdriver
To install the ETEP on a solid surface:
1Place the unit on a solid surface, with the bottom panel facing up.
2Locate the four screw holes on the bottom of the unit (Figure 17).
ETEP Installation Guide | 31 |