![](/images/new-backgrounds/1156968/15696821x1.webp)
Product Overview
Status Indicators
The ET0010A status indictors are shown in Figure 3. The status indications are described in Table 1.
Figure 3 ET0010A Status Indicators
Elements of Figure 3:
1)Power LED
2)Alarm LED
3)Status indicators
4)Link indicators
The following table describes how to interpret the ET0010A status indicators.
Table 1 | ET0010A Status Indicators | ||
|
|
| |
Indicator Light | State | Indication | |
Power (green) | Off | Unit is powered off. | |
|
| On | Unit is powered on. |
10/100 link status | Off | Loss of signal on the 10/100 link. | |
(green)a |
|
|
|
| On | The 10/100 link is up but no traffic is passing over the link. | |
|
| ||
|
| Blinking | Indicates the presence of traffic on the 10/100 link. |
Gigabit link status | Off | Loss of signal on the Gigabit link. | |
(amber)a |
|
|
|
| On | The Gigabit link is up but no traffic is passing over the link. | |
|
| ||
|
| Blinking | Indicates the presence of traffic on the Gigabit link. |
Alarm (green) | Off | Normal operation. | |
|
| On | The unit is in an error state. This occurs when the |
|
|
| diagnostics detect a boot failure, a critical error threshold is |
|
|
| exceeded, or a FIPS test fails when the ETEP is in FIPS |
|
|
| mode. |
Status (1,2,3,4) | Off | Unit is up and operational. | |
|
| On | Displays diagnostic codes during boot up. |
|
|
|
|
a. The link status LEDs are on the remote and local data ports, Ethernet management port, and Aux1 port.
12 | ETEP Installation Guide |