Diagnostic Code Display
If the ETEP is discarding traffic, check the system log for temperature warning notices to confirm that a temperature error occurred. Reboot the ETEP to resume normal operation.
Diagnostic Code Display
ETEPs display
●“Status Codes: ET0010A” on page 63
●“Diagnostic Codes: ET0100A and ET1000A” on page 64
Status Codes: ET0010A
The ET0010A status LEDs display
When the appliance powers up, the Alarm LED illuminates briefly and the four status LEDs illuminate to verify that they are functioning. As the ET0010A cycles through its
If the ET0010A fails to boot properly the illuminated status LEDs indicate the number of the last test that completed successfully, and a message describing the failure is displayed on the terminal. In addition, the Alarm light illuminates if any of the first four
Table 25 | ET0010A |
| |
|
|
| |
Status LEDs Illuminated |
| Description | |
1, 2, 3, 4 |
|
| LED display test. |
1 |
|
| Bootflash CRC test. |
2 |
|
| DRAM test #1. |
1, 2 |
|
| Initialize IO devices. DRAM test #2. |
3 |
|
| Initialize compact flash. |
1,3 |
|
| Complete bootloader initialization. |
2,3 |
|
| Download operating system. |
1, 2, 3 |
|
| Start operating system, IPSec dataplane code, and management |
|
|
| and control software. |
All status LEDs off |
| Up and operational. | |
|
|
|
|
After the ET0010A boots up, the status LEDs reflect the operational state of the appliance.
.
Table 26 ET0010A Operational Codes
Code | Description |
All status LEDs off | Up and operational. |
2, 3, 4 | The ET0010A is in a shutdown state. |
|
|
ETEP Installation Guide | 63 |